I was just curious if cutting chipboard with your cutting machine, (assuming that you have a cutting machine that says you CAN) dulls your blade and makes your machine run not so good after you do it? I am asking because a lot of things SAY that you can do something but that doesn't always mean that you should for the health of your device?? I hope this makes sense
I don't have any of the electronic machines but have a Sizzix BigKick and cut chipboard all the time with Sizzix Original and Bigz dies and they haven't dulled at all. I haven't been successful cutting chipboard with the Sizzlets. I also have an Accucut GrandMark and it cuts chipboard perfectly.