whole princess body if possible... I found a princess body on another site but when I go to open it I get an error message saying its out of the range of the paper size able to be drawn up... any sug?

Which software are you getting that in? It rings a bell, but can't remember how to resolve it...

in the craft robo software...

I'm going to PM you a link...

I have the KNK and I am having MAJOR problems cutting chipboard. When I used the normal blade on cardstock it cuts perfect but then when I switch to the sliver blade and try chipboard it never cuts along the same lines. Any ideas?

Sorry, I don't know a darn thing about the KNK. Do they have a tech support e-mail?

I'm a new owner of a Pazzles Inspiration. What is the best way to go about adding these files to my existing files and keeping them organized?

What I did is make a main folder for my cutting files, and then folders under those by type. I have one for animals, flowers, flourishes, etc.

Whatever you do, do it from the start...when I first got my Wishblade, I threw everything in ONE folder. When it got to the point where I needed to sort them...THAT was a huge mess!!!!

Thanks for the quick reply. I'll start making folders!

Any suggestions on where to find a big tire (like where a title would fit inside it)?

How do I open or save these files? I've tried it both with my Pazzles program opened and closed.

Thanks,
Marsha

You probably can't open them directly - save them to your hard drive, then do a file, open.