Username Post: Can´t make my Gazelle work with Windows 7        (Topic#1549637)
kottens
Idol
Posts: 5269
Joined: 10-20-09
kottens

I got a new laptop a couple of weeks ago and installed the Gazelle on it. It worked on my old one with Windows XP, but I can´t make it work on the new with Windows 7. All I get is "USB Error" everytime I try to cut something. I´ve got Funtime III.

I´ve used every possible combination on my USB ports, but the Gazelle is not showing up as a printer when I look in the control panel. It did when I had XP.

Anyone experienced this before? Any advice? It´s just collecting dust right now and I´d like to use it again.


 
stick
stick 
Mayor
Posts: 13101
Joined: 05-01-09
stick
  • stick on 12-30-10 02:01 PM
In response to kottens

Have you looked at the BossKut forums? There's an instruction for how to install on Windows 7, I believe all I had to do was download a new driver or something - it was easy


 
kottens
Idol
Posts: 5269
Joined: 10-20-09
kottens
In response to stick

No I haven´t. I´ve got a friend who bought a new laptop as well and her Gazelle worked fine without any new drivers so I didn´t even think about that.

Thanks, I´ll check it out.


 
Permissions Topic Options
2800 Views
Recent Topics