Username Post: how to use brads? please advise
Posts: 10989
Joined: 08-09-07

    In response to ckair

It won't bend your paper if you use something else to make the hole, then insert the brad. I use a hole puncher that makes a tiny hole, or if it's further in on the paper that the hole punch won't reach, I use a paper piercer to make the hole. I have a self-healing mat on my scrap table so I don't have to worry about the piercer leaving a mark or hole on my table. Hope this helps.

NOTE: You are viewing an individual post. View the Entire Topic