Please Help! How do I set an eyelet in my page?

You have to make a whole in the page. I suggest the MM Eyelet setting tool. I don't like the M'bellish one (that you get from Wal-Mart) - but that is apparently your problem. You need to get a whole in the paper

thank you all so much for all the information! I am now proud to say that I can set an eyelet on my page Yeah! Jennifer

I think if that happened to me, I would be so and then I would . DO you need a ?

i was so excited to get my mm tool set, drove an hr to get it and got it with a coupon, came home and the daggone thing is broken, the paper piercer is completely broken of . smack dab it, i was so planning on doing things with it. got eyelets on clearance and everything. so back tomorrow to acmoore and return the poor broken set. wahhhhh

This may be a stupid question, but why doesn't MM include instructions in the package?? When I first got my tools, I didn't realize the hole punch and setter were different, and lodged an eyelet in the middle of my hole punch! Took a little work to get it out, too!

Check out the each one, teach one thread at the top of this forum....there's a great tutorial how to set an eyelet.


eyelet setting

The one with the black interchangeable tip with the holes in them are the paper punches. The one metal tool with the ,um, how do I explain... Flower-like maybe? end, that is the one you use to set it.

First you match up the black metal hole punch to the eyelet to figure out which size hole you need. Then, you put that tool into the paper and tap it with the hammer to get the hole in your paper. Then you put your eyelet in the hole (The front of the eyelet, obviously, on the front of your work.) Turn your paper over so that the back of the eyelet and paper are facing up. Then set the "felower-ish" tool over the eyelet and pound! This will flay out the eyelet and set it. Now flip over your paper and viola! You have et your eyelet!

I hope this made sense! Good luck!

Beth

I have the eyelet tools that came with the MM set, but I"m not sure which one is the hole punch and which one is the eyelet setter?! Sorry if these are ignorant questions - I'm rather frustrated with the eyelets. Thank you for the above reply!

Did you make a hole first? You need to use a hole punch, or something to make a hole in the paper. THEN place your eyelet. Place your eyelet setter on/in the eyelet and it THAT with the hammer.

Do you have a hole punch and setter?

I have MM eyelets (heart metal letters) and metal eyelets. I am using the hammer and a setting mat, but I keep smashing the eyelet and it never penetrates the paper. I don't understand how to get the eyelet to go through the paper. Any suggestions would be appreciated! I'm ready to just use a sticker and move on